Built using aluminium sections with sanitation baseboard. A seal is installed on the section to guarantee the air-tightness of the union with the panels. The union between sections is carried out using pressure cast angled nylon joints. We also have models with high pressure joints. Available as an optional treatment for corrosive environments and interior and exterior stainless steel finishes.
We adapt the supporting structures to the needs of the client, occasionally manufacturing supporting structures such as feet supports, Omegas or perimeter frames depending on the fixing needs of each installation. The frames may be made of a UPN profile forming a self-supporting base.
The standard panels are 25 to 45 mm thick sandwich type panels with an oven painted outer panel, with the RAL colour chosen by the client. On special order, we can supply units with up to a 100 mm thick panel and a galvanised, lacquered or stainless steel interior finish. We also have acoustic interior panels for low noise level units.
Inspections doors that facilitate conducting maintenance on the unit and ensure watertightness under overpressure as well as low pressure conditions.
Manufactured in stainless AISI304 steel and with a drop to collect condensates as standard. The outlet tube provides 3/4" with a 20 mm outer thread to connect with the drain system. Thermal insulation is installed on the outside.
The regulation gates are entirely manufactured using extruded aluminium with aerodynamic mobile slats and an airtight seal.
Movement is transmitted using gears with a shaft ready to install actuators or manually actuated handles. These handles can be supplied in steel or aluminium.